Time Settings Page; System Page - Sony MKS-R4020 Operating Instructions Manual

LAN1, LAN2: Select the LAN to use by the host specified in
[Allowed Host2].
TRAP
Enable Trap: Place a check mark in the checkbox to enable
sending of traps.
Community Name (trap): Set the community name used
when sending traps.
Send Authentication trap: Place a check mark in the
checkbox to send authentication traps.
SNMP Trap: Specify the destination host for sending traps.
SNMP Version: Select [v1] or [v2c] as the SNMP trap version.
NIC: Select [LAN1] or [LAN2] for the LAN on which to send
traps.
Target IP Address: Specify the IP address of the host to
which to send traps.
Syslog Settings
Enable SYSLOG
Place a check mark in the checkbox to use Syslog.
LAN1 IP Address
Specify the IP address of the Syslog server connection from
LAN1.
LAN2 IP Address
Specify the IP address of the Syslog server connection from
LAN2.
Note
If a check mark is not placed in [Enable Redundancy] on
the [Network Settings] page, logs are not sent from LAN2.
Severity
Specify the Syslog severity level.
Note
Logs with the specified severity level and higher
importance levels will be sent.

Time Settings Page

Use to configure settings related to the date and time.
Time Zone Settings
Time Zone
Set the time zone.
Date and Time Settings
Set time automatically
Automatically set the time using an NTP server. Configure
the NTP server settings on the [Network Settings] page.
Time setting
Use to set the date and time manually.
Note
• The [Date and Time Settings] configuration is applied
when the [Apply] button is clicked.
• If the time is not set correctly on the unit, the
communication with the system controller or a web
browser may not be performed correctly.

System Page

Use to configure settings related to the system.
Error Settings
Enable DC In Error
Enable output of DC IN power supply errors.
System Settings
Name: Enter the name of the remote control panel.
User: Enter the user name of the remote control panel.
Description: Enter a description of the remote control
panel.
Password Settings
Use to change the password for the admin user for
accessing the web menu.
Old Password: Enter the old password.
New Password: Enter the new password.
Verify: Enter the new password again.
Click the [Change] button to update the password.
Notes
• The password "MKSRadmin1" is configured by factory
default.
• The user name (admin) cannot be changed.
• The password is reset to the factory default when the
software is reset using [Reset all settings].
• The [Name], [User], and [Description] settings are
applied when changes are confirmed.
Save/Restore Settings
Save/Restore user default
Save the user settings status.
Save: Save the current settings status to the backup region
with a new name.
Restore: Restore the specified settings status saved in the
backup region.
Export/Import settings
Export: Download the current settings status as a binary
file.
Import: Upload a configuration file from a web browser.
Reset all settings
Restore all menu settings to their default state.
Notes
• Changed passwords are restored to the default state,
and the password setup dialog will be displayed the next
time you log in.
• The network settings of the remote control panel are
also reset.
21