Figure 3.3 Back Panel Components - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
 The OS7200 MCP/MP20, 4WLI and WIM module are NOT allowed in an OS7400 system.
 Although the MGI64 and TEPRI2 can be installed in any universal slot of the OS7400
expansion cabinet, it is recommended that they be installed in the main cabinet in order
to utilize the full capacity of the cards. The main cabinet slots are 64 channel slots and the
expansion cabinet slots are only 32 channels. Therefore, installing a TEPRI2 or MGI64 in
the expansion cabinets will only give you half of the capacity for these cards. Installing
them in the main cabinet will give you the full capacity of these cards.
 A maximum of 1 GWIM/GWIMT per cabinet and 2 GSIMs per cabinet can be installed.
Every OS7400 cabinet must have an LP40 card installed in slot 0 including the
main cabinet. Even a single cabinet system requires an LP40 card. If the
expansion cabinet is an OS7200 cabinet, then it must have an OS7200 LCP card
installed in slot 0.
IMPORTANT:


Battery Receptacle

Battery Switch

DC LED

AC LED

AC Power Connector

Fuse Holder

AC Power Switch

Handles for Mounting or Unmounting Power Module

Connector for OS7150 PoE PSU

Ground Lug

Figure 3.3 Back Panel Components

3.4
Home Page Home Page Table of Contents Table of Contents
INSTALLATION
PART 3 MAY 2010