And The Fixed Needle Guard; To Adjust The Clearance Between The Needles And The Fixed Needle Guard - Janome FOUR-DBL Service Manual

TO ADJUST THE CLEARANCE BETWEEN THE NEEDLES

AND THE FIXED NEEDLE GUARD

Correct Setting:
The clearance between needle and the fixed needle guard should be 0.1 to 0.4 mm.
To adjust:
1. Remove the presser foot and the needle plate and lower the needle to its lowest position.
2. Loosen setscrew A and adjust the position of the fixed needle guard.
3. Tighten setscrew A.
4. Attach the needle plate and the presser foot.
Needle plate setting knob
should be set at "S"
Chaining finger
Fixed needle guard
Needle plate setting knob
should be set at "S"
To be touched
Setscrew A
Needle plate setting knob
17
The clearance between the needle
and fixed needle guard
Fixed needle guard
0.1 ~ 0.4mm
Tip of fixed needle guard
Needle #14