Table of Contents
Advertisement
2-3-2. Setting the Microphone
This unit can output the two independent microphone lines
(MIC 1, MIC 2) of video camera HDC-F950 as it receives
these MIC signals.
Controlling the Microphone Input Gain Using the
Remote Control
This unit can adjust the input gain of the MIC connector of
camera HDC-F950 using the remote control in the range of
60 dB to 20 dB in 10 dB steps using either of the following
methods.
1. Adjusting the microphone input gain using
the MIC LEVEL switch
MIC LEVEL switch
When the MIC REMOTE connector on the rear is connect-
ed to nothing or the levels of pin-8 (MIC 1) and pin-15
(MIC 2) of the MIC REMOTE connector are High, use the
MIC LEVEL switch on the AVP-4A board panel of the
unit to set the microphone input level.
Factory setting : NORM (60 dB)
2. Adjusting the microphone input gain using
the MIC REMOTE connector
Set the microphone input gain control to ON or OFF via
pin-8 and pin-15 of the MIC REMOTE connector on the
rear as shown below. The input gain can be controlled via
pin-5, pin-6 and pin-7 as shown in the table on the top-
right.
Setting the microphone input control of the video camera
Pin No.
Microphone connector
8
15
MIC IN CH-1
L
L
ON
L
H
ON
H
L
OFF
H
H
Internal setup (MIC LEVEL switch on the
AVP-4A board panel)
HDCU-F950 IMM
AVP-4A board (panel side)
MIC IN CH-2
ON
OFF
ON
Setting the microphone input gain of the video camera
Pin No.
7
60 dB
H
50 dB
L
40 dB
H
30 dB
L
20 dB
H
H :
+5 V or OPEN
L :
GND
Input resistance : Pulled-up 100 kZ +5 V
The setup for HDCU-700A mode is shown in parenthesis ( ).
In the case of HDCU-700A mode : S423-2/AT-149A → ON
3. Adjusting the MIC signal phase
S15
When the PGM microphone signal phase is in advance
with respect to the video signal phase in use, adjust the
audio phase using the switch S15 (MIC DELAY) on the
AVP-4A board to adjust amount of audio delay. Each step
of the switch corresponds to about 5 ms delay.
Example
7 : 1 FRAME DELAY (30 FRAME/SEC)
8 : 1 FRAME DELAY (25 FRAME/SEC)
Factory setting : 0
6
5
H
H
H
H
L (H)
H (L)
L (H)
H (L)
H (L)
L (H)
AVP-4A board (A side)
2-7 (E)
Advertisement
Table of Contents
