Table of Contents
Advertisement
3-3. Character Display Function
This unit has the built-in character generation circuit. The
character information such as the settings, state and self-
diagnosis of the unit can be mixed with the HD SDI video
signal. The mixed signal can be output from the MONI
OUT (DRX-1A board output) and the HD SDI OUT (FC-
94 board output) connector respectively. They can be
displayed on the HD monitor.
The character MIX function can be forcibly turned OFF by
turning OFF S202-4 (HD SDI) on the DRX-1A board.
Required equipment
. HD monitor
Sony BVM-D20F1U or equivalent
. Remote control unit
Sony RCP-700 series
. HDVS camera system
HDC-F950
Operating procedure
In order to show the setting, the state and the self-diagnosis
display on the HD monitor, press the CHARACTER
button of the RCP so that the button lights, or operate the
CHARACTER switch on the panel surface of the DRX-1A
board.
To change the page, press the CHARACTER button of the
RCP. The page can also be changed by pressing the
CHARACTER switch on the panel surface of the DRX-1A
board panel.
When the CHARACTER button of the RCP (or CHAR-
ACTER switch on the panel surface of the DRX-1A board)
is kept pressed, the pages are changed continuously. After
all the pages are displayed, the cycling display stops on the
final page and the CHARACTER button of the RCP goes
off. To display the character information again, press the
CHARACTER button of the RCP.
n
The first page is blank. When selecting the first page, the
display of characters is OFF.
CHARACTER switch
3-4 (E)
S202
S203
DRX-1A board (A side/panel side)
The contents of the pages displayed on the HD monitor (or
SD analog monitor) are as follows.
Page
Title
0
Displays OFF (CHARACTER button
OFF)
1
Camera Lens/Filter Status
2
Camera Status
3
System Status
4
Diagnosis
5
System Diag 1/3
6
System Diag 2/3
7
System Diag 3/3
8
AT Diag
9
AVP Diag
10
DTX Diag
11
DRX Diag
12
Slot-5 Diag
13
Slot-6 Diag
14
ROM Version
HDCU-F950 IMM
Advertisement
Table of Contents
