Changing The Presser Foot Sole - Bernina 570 QE User Manual

BERNINA Stitch Regulator (BSR)
> Insert the plug for the cable vertically into the BSR connection (1) until you feel it click into place.
1
> Switch the machine on.
– The BSR display opens and the BSR 1 mode is activated.

Changing the presser foot sole

NOTICE The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The standard stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten
the stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the BSR foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the BSR foot from the machine.
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot.
124