Table of Contents
Advertisement
11.5 Sewing preparations for quilting
Attach the BSR presser foot
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
> Change the presser foot.
> Insert the cable of the BSR foot into the connection (1).
1
> Switch the machine on.
– The BSR display opens and the BSR 1 mode is activated.
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The basic stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten the
stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot (see page 43).
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot (see page 145).
BERNINA Stitch Regulator (BSR)
145
Advertisement
Table of Contents
