(All Special Models) - KTM 250 EXC TPI Owner's Manual

12.12 Installing the lower triple clamp

(All special models)

Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Mount protective ring
B01218-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line and wiring harness.
E00927-10
–
Position the combination instrument holder, and mount and
tighten screws
Guideline
Remaining screws,
chassis
S03515-11
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB
(red adjuster). The compression damping is located in
left fork leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
S03463-11
be flush with the upper edge of the upper triple clamp.
SERVICE WORK ON THE CHASSIS 12
p. 168)
1
2 3
and O-ring .
4
, but do not tighten yet.
5
.
M6
6
are positioned toward the front.
is correctly posi-
10 Nm (7.4 lbf ft)
73