Installing The Projector Horizontally By Adjusting The Height Of Either Side - Epson EH-LS500W User Manual

Preparing

Installing the projector horizontally by adjusting the height of either side

If the projector is tilted, the projected image is also tilted.
Install the projector horizontally so that both sides are at the same height.
Warning
•
Do not set up the projector in locations exposed to humidity or dust, or in locations exposed to oil smoke or
steam such as on a kitchen counter, in the kitchen, or near a humidifier. Doing so could cause fire or electric
shock.
•
Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such as
sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also cause the
projector to malfunction.
•
Do not install it on an unstable shelf or in a place out of load range. Otherwise, it could fall or topple causing
an accident and injury.
•
When installing the projector in a high position such as on a shelf, take measures against falling by using
wires or belts to ensure safety in an emergency such as an earthquake, and to prevent accidents. If it is not
installed correctly, it could fall causing an accident and injury.
•
Do not block the air intake vent and air exhaust vent of the projector. Blocking its air intake vent and air
exhaust vent may trap heat inside causing fire.
•
Do not place a cloth or any paper under the projector. The cloth or paper could be sucked up by the Air intake
vent on the bottom of the projector during projection causing the internal temperature to rise which could
start a fire.
Attention
•
Do not use the projector installed vertically. Doing so could cause a malfunction.
•
We recommend cleaning the air filter every 20,000 hours. Clean it more often if the environment is particularly
dusty. p.83
s
15