Table of Contents
Advertisement
Warning:
Ensure the server is powered off before you connect the external SCSI tape drive
The terminator is not a hot-plug device. If you replace the terminator, or if you add an external
SCSI peripheral, the server must be powered off. If you replace the terminator or add a SCSI
peripheral when the system is on, the system can crash.
1. Power off the server and the tape drive.
2. Set the SCSI ID push button switch, located on the back of the tape drive, to 6.
3. Connect the external SCSI tape drive to the SCSI port in the rear panel, Label C on
Figure 8: SCSI tape drive with terminator
4. Install the SCSI tape drive terminator to the back of the SCSI tape drive, as shown in
Avaya CallPilot® 600r Server Hardware Installation
Note:
For the proper shutdown procedure, see the chapter, "Starting up and shutting
down the CallPilot server" in Installation and Configuration Task List
(NN44200-306).
the rear panel diagram, as shown in
Note:
You must remove the server terminator before you connect the tape drive to the
server. Keep the server terminator in a safe place, as you may need the server
terminator when you want to use the server, and the tape drive is not available
to terminate the SCSI bus.
Figure 8, under the label Tape drive terminator.
To connect the external SCSI tape drive
Figure 7: Rear panel
on page 31.
December 2010
33
Advertisement
Table of Contents
