Cisco Catalyst IE3400 Heavy Duty Series Installation Manual page 18

Warnings
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) requirements
in IEC 60950 based safety standards. Statement 1033
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection.10/100/1000 Ethernet, Console,
and Alarm Statement 1044
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of: 140°F (60°C) Statement 1047
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Caution Airflow around the switch must be unrestricted. To prevent the switch from overheating, there must be the
following minimum clearances:– Top and bottom: 2.0 in. (50.8 mm)– Sides: 2.0 in. (50.8 mm)– Front: 2.0
in. (50.8 mm)
Caution If installer is providing cabling for an IP66/IP67 and Type 4X rated environment, the cables must be suitably
rated for IP66/IP67 and Type 4X requirements
Cisco Catalyst IE3400 Heavy Duty Series Hardware Installation Guide
10
Switch Installation