Adjusting The Anti-Scalp Rollers; Adjusting The Flow Baffle Knob - Toro Z Master Professional 5000 Series Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
27, Figure 28, and
Figure 27
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 28
1. Anti-scalp roller
2. Bushing
Figure
Figure 29.
4. Flange nut
5. Bolt
3. Flange nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing
Adjusting the Flow Baffle
Knob
This procedure is applicable only to machines with the
flow baffle knob. Certain models have nuts and bolts
in place of the flow-baffle knob and can be adjusted
the same.
g029955
You can adjust the mower discharge flow for different
types of mowing conditions. Position the knob and
baffle to give the best quality of cut.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the knob.
4. Slide the knob to the desired position.
5. Tighten the knob.
g029956
28
Figure 29
4. Flange nut
5. Bolt
g029957