Mounting The Pressure Piece Set; General Installation Information; Overview - Siemens SIWAREX WL270 CP-S SB Operating Instructions Manual

Pressure piece set

Hide thumbs Also See for SIWAREX WL270 CP-S SB:

Table of Contents

5.2

Mounting the pressure piece set

5.2.1

The installation conditions vary widely. The dead load of the load bearing implement can be

very low or relatively high. You might be dealing with a container, platform or a roller

conveyor. The following installation instructions can therefore only describe the general

procedures.

Always set up the load bearing implement on dummies in order to protect the load cells from

damage during installation.

The load bearing implement then only has to be raised a few millimeters from bracket to

bracket in order to position the pressure piece set. The following description of the

installation is based on this assumption.

Note

Maintenance-friendly design

When planning the layout, ensure that the load cells are easily accessible once they are

installed.

Depending on the installation conditions, the detailed procedure may deviate from the

following description.

5.2.2

The following actions are required in order to install the pressure piece set.

1. Preparing the load cell

2. Preparing the pressure piece set

3. Installing the load cell with pressure piece set

4. Checking the installation

The actions are described in detail in the following.