Troubleshooting - Procedures - Sundance Spas 850 Installation & Owner's Manual

14.0 Troubleshooting - Procedures

In the unlikely event your hot tub is not working the way you believe it should,
please first review all installation and operating instructions in this manual and
check the message on the panel display; second, if you are still not satisfied
it is working properly, please follow the appropriate troubleshooting instruc-
tions.
PROBLEM
NONE OF THE
COMPONENTS
OPERATE (i.e.
pump, blower, light)
PUMP DOES
NOT OPERATE
BUT BLOWER
AND LIGHT DO
OPERATE
Pump Priming Instructions: Turn Hot Tub Off!
Remove filter and insert end of garden hose into left-side filter fitting.
Seal-off fitting opening around hose using a large, clean rag and hold in
place. Ask a helper to turn on maximum water flow through the garden
hose. After about 30 seconds, turn off water. Repeat process for right-side
filter fitting, then remove hose and rag. Reinstall filter as illustrated in
section 1 1.1 (page 28-29) and activate pump 1. Another method of
priming the hot tub's pump(s) is as follows:
1. Turn off the power to the hot tub.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger-tight, replace the handle and turn the hot tub's
power back on.
PROCEDURE
Check the control panel lights.
1. If there are letters or symbols displayed on the
screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
a. Check the household circuit breaker.
b. Contact you dealer or authorized service center.
Depress "JETS" sensor.
1. If no sound is detected or if a "buzzing" sound is
detected, turn off power to the hot tub and
contact your dealer or service center.
2. If motor operates but no water flows to jets:
a. Pump may not be properly primed. See
instructions below.
b. Contact dealer or authorized service center.
ENGLISH
Page 37