Programming The Change Filter Reminder; Programming The Optional Ozonator Cycle - Sundance Spas 850 Installation & Owner's Manual

850 export series
Hide thumbs Also See for 850:
Table of Contents

Advertisement

ENGLISH
At any time, you may check the programming of any aspect of the
skimming/heating cycle by first pressing CYCLE then moving through the
menu by pressing either CYCLE or SELECT. The programming is changed
only by pressing UP or DOWN during this process.

10.3 Programming The Change Filter Reminder

Your new spa is equipped with a programmable "Change
Filter" reminder that appears on the control panel display
after a specified number of days. It is designed to remind
you to clean and/or replace your filter cartridge(s) on a regular basis but
does not affect spa operation in any way. This reminder must be reset at
each filter cleaning interval. It offers a selectable range from 10-120 days
or can be disabled. We recommend an initial setting of 30 days, after
which you can easily determine whether you need to shorten or lengthen
its interval by visually inspecting your filter cartridge. Refer to section 1 1.1
(page 28) for filter cleaning recommendations.
Programming Instructions
(1) Press the CYCLE sensor three times. The main display reads "FIL"
indicating the "Change Filter" display program has been accessed.
(2) Press SELECT sensor once to display currently programmed duration or
days elapsed since last filter cleaning interval.
(3) Press UP or DOWN sensor to change duration as follows:
0 - 10 - 20 - 30 - 40 - 50 - 60 - 70 - 80 - 90 - 100 - 1 10 - 120 - OFF
(4) Press DISPLAY sensor once to save changes and return to the
standard water temperature display. Note: If no sensor is pressed
within 30 seconds, the screen will automatically return to the standard
water temperature display.

10.4 Programming The Optional Ozonator Cycle

The Sentry control system allows you to easily adjust two separate aspects
of the ozone cycle:
• The time of day (start time) the ozonator begins operating.
• The length of time (duration) the ozonator operates.
Programming Procedure:
(1) Press the CYCLE sensor once. "Adjust 1" indicator displays.
(2) Press CYCLE sensor a second time, "Adjust O 3 " indicator displays.
Page 26
CHANGE
FILTER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents