Reassembly Process - Alcatel ONETOUCH POP 3 Series Repair Documentation

L2 Repair Document
Disassembly Notice:
1) Take care not to damage several FPCs when you are using plastic flake to separate the furnished
frame from the furnished front casing.
2) Be careful not to damage TP FPC and LCD FPC during disassembly process.
Put all the spare parts on right position (don‟t let all the spare parts mixed and put on the clean place to
3)
avoid vitiated or stained for each spare part) after disassembly.
For packaging method please refer item "APPENDIX 1 Packaging Requirements".
4)

5.4 Reassembly Process

Please make reference to the disassembly process for assembly reverse an order of the disassembly
steps.
Attention:

When assembling main PCBA, make sure the sub camera, p-sensor rubber, receiver and receiver
bracker are well installed firstly.

Please notice the distinction between the anode and the cathode when assembling vibrator and
speaker.
Rev.
1.0
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
5015D/X/A/E_5016A/J Level 2 Repair Document
TCL
Communication Ltd.
Page
30/42