Installer Setting - Thermistor - LG PQRCVSL0 Owners & Installation Manual

Installation Instructions
Function code,
ESP code
ESP value
•
Please be careful not to change the ESP value for each fan step.
•
It does not work to setup ESP value for very low/power step for some products.
• ESP value is available for specific range belongs to the product.
14 New Wide Wired Remote Controller
6 Select ESP fan step again by using
button and set up the ESP value, as No.
4 and 5, that corresponds to each wind
flow.
7 Press button to save.
Pressing the button will exit the
8
settings mode. If is not pressed, the
remote controller will automatically exit
setup mode after 25 seconds with no
input. If the set button is not pressed, the
changes will not take effect.

Installer Setting - Thermistor

This is the function to select the temperature sensor to judge the room temperature.
Thermistor Table
Temperature sensor selection
01 Remote controller Operation in remote controller temperature sensor
02 Indoor unit Operation in indoor unit temperature sensor
Operation of higher temperature by comparing indoor unit's and wired
Cooling remote controller's temperature.
03 2TH (There are products that operate at a lower temperature.)
Operation of lower temperature by comparing indoor unit's and wired remote
Heating
controller's temperature.
E
The function of 2TH has different operation characteristics according to the product.
Installation Instructions
Pressing and holding the button
1
for 3 seconds enters the remote
controller setup mode. If it is not held
for 3 seconds, it enters the user setup
mode.
2 If moving to room temperature perception
sensor selection menu by pressing
button, it indicates as pictured below.
Set Thermistor value by pressing
3
button. (01: Remote Controller,
02: Indoor, 03: 2TH)
Function Code Thermistor setting
Press button to save.
4
Pressing the button will exit the settings
5
mode. If is not pressed, the remote
controller will automatically exit setup mode
after 25 seconds with no input. If the set
button is not pressed, the changes will not
take effect.
Function
Owner's & Installation Manual 15