INSTALLATION
58
• If you set as Master-Master or Slave-slave for both remote controllers, the following pop-up is
displayed once within 10 minutes after power-on.
If you use the 2-remo function, through the master remote controller you can check the
temperature where the remote controller set as slave is installed.
The room temperature icon changes. This means that the value is detected by the slave remote
controller.
INSTALLER SETTING
How to enter installer setting
CAUTION
!
The installer setting mode is the mode to set the remote controller's detail function. If the
installer setting mode is incorrectly set, it may cause product failure, user's injury, or property
damage. It must be set by the installation specialist with the installation license, and if it is
installed or changed without installation license, all problems caused will be the responsibility of
the installer, and may void the LG warrenty.
• In the menu screen, press [<,>(left/right)] button to select the setting category, and press
[∧(up)] button for 3 seconds to enter the password input screen for the installer setting.
• Input the password and press [OK] button to move to the installer setting list.
OK
※Installer setting password
Main screen → menu → setting → service → RMC version information → SW Version
Example) SW version : 1.00.1 a
In the above case, the password is 1001.
NOTE
Some categories of the installer setting menu may not be available depending on the
product function or the menu name may be different.
INSTALLER SETTING
59
OK