Alarms and Hourly Time
Signal
The watch will beep when the alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The alarm sound is muted in the cases
●
described below.
When battery power is low
ー
When watch is at Level 2 power saving
ー
Power Saving Function
l
Configuring Alarm Settings
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (E) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm number
Alarm time
3.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
Hours
Operation Guide 5608
4.
Use (B) and (E) to change the hour setting.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (D).
This causes the minutes digits to flash.
6.
Use (B) and (E) to change the minute
setting.
7.
Press (D).
This causes the alarm type to flash.
8.
Use (E) to select the alarm type.
[DAILY]: Alarm sounds every day at the
alarm time.
[1TIME]: Alarm sounds only once at the
alarm time.
[SCHEDULE]: Alarm sounds on the
specified date.
Setting a Schedule Alarm
l
9.
Press (A) to exit the setting screen.
[ALM] is shown on the display while an
●
alarm is set.
10.
Hold down (D) for at least two seconds to
return to the Timekeeping Mode.
Note
A beeper sounds for 10 seconds when
●
the alarm time is reached.
You can also use G-SHOCK
●
Connected to configure alarm time
settings.
Minutes
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
Setting a Schedule Alarm
With [SCHEDULE], you can specify the year,
month, and day that you want an alarm to
sound.
Creating a Schedule Alarm
●
There are various schedule alarm variations,
and the variation that is set depends on the
year, month, and day settings you configure.
Three typical setting configurations are shown
below, but other configurations are also
possible.
A Year, month, day all specified
The alarm sounds once at the specified time
on the specified date.
B Year, month, day partially specified
Specifying only the year will cause the
●
alarm to sound at the specified time
every day of the specified year.
Specifying only the month and day will
●
cause the alarm to sound at the
specified time on the specified date
every year.
You can also create a schedule alarm by
specifying the month only, day only, year and
month only, and year and day only.
C Year, month, day not specified (Display:
[----.--.--])
In this case, the alarm will sound at the
specified time every day.
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (E) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm number
Alarm time
13