Setting The Alarm; Adjusting Hand Alignment; Phone Finder; Configuring Watch Settings - Casio 5608 Operation Manual

Setting the Alarm

1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to e .
If connection fails for some reason,
●
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
3.
Y Perform the operation shown on the
phone screen to configure alarm time
settings.

Adjusting Hand Alignment

If the hands are out of alignment even though
auto time adjustment is being performed, use
G-SHOCK Connected to adjust them.
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to e .
If connection fails for some reason,
●
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
3.
Y Perform the operation shown on the
phone screen to correct hand alignment.
Operation Guide 5608

Phone Finder

You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
Do not use this function in areas where
●
phone call tones are restricted.
The tone sounds at a high volume. Do
●
not use this function when listening to
phone output over earphones.
1.
X If the watch is connected with a phone,
Connected
press any button to terminate the
connection.
Connected
2.
X If the watch is in any mode besides the
Timekeeping Mode, hold down (D) for at
least two seconds to enter the
Timekeeping Mode.
3.
X Hold down (E) for at least 1.5 seconds
until the second hand moves to [R].
The phone will sound a tone when it
establishes a connection with the watch.
It will take a few seconds before the
●
phone tone sounds.
Searching for phone
4.
X Press any button to stop the tone.
You can press any watch button to stop
●
Connected
the phone tone only during the first 30
seconds after it starts to sound.

Configuring Watch Settings

You can use G-SHOCK Connected to specify
the amount of time until a Bluetooth
connection is automatically terminated, to
enable or disable the watch operation tone,
and to configure other settings.
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to e .
If connection fails for some reason,
●
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Disconnected
Trying to connect
3.
Y Select the setting you want to change
and then perform the operation shown on
the phone screen.
Connected
Connected
8