Grind Setting Selection - Sunbeam Intuitive EM8910 Instruction Booklet

Grind setting selection

Important: Only adjust the fineness of
the grind during the grinding process.
Adjustments of the grind while not in use
may cause damage to the espresso machine.
Setting the fineness of the grind
• With a cup placed under the espresso pour
spout, press the
button. While the grinding process is
running, adjust the fineness of the grind
using the 'coffee grind selector' lever. See
figure 35.
Figure 35
Figure 36
26
one cup coffee
Removing foreign matter from the grinding
mechanism
Foreign matter in the grinder, e.g. small
stones or wood chips, may cause damage to
the grinding mechanism.
The Sunbeam Intuitive Digital is designed
with a 'stone safety device' which, in case of
foreign matter, causes an even, loud rattling.
If you should hear this noise during grinding,
switch the espresso machine off immediately
and remove the foreign matter as follows:
Cleaning the grinding mechanism
• Switch the espresso machine off by
pressing the 'POWER' button and unplug
the power cord from the power outlet.
• Turn the 'coffee bean hopper' to the
position marked 'HOPPER RELEASE' and
take it off. See figure 36.
• Remove any coffee beans in the grinding
mechanism. We suggest using the cleaning
brush supplied with the Sunbeam Intuitive
Digital (or, possibly a vacuum cleaner with
a hose or nozzle). See figure 37. If any
foreign matter cannot be removed, proceed
with the next step.
• Slide the 'grinding mechanism release'
button to the front in the direction of the
grinding mechanism. Hold this position
and turn the 'coffee grind' lever clockwise
by approximately 1 revolution up to the
stop. See figure 38.
• Now detach the grinding ring by lifting it
out and remove any foreign matter(s).
See figure 39.
Important: There is risk of injury by turning
grinding gear. Never switch the espresso
machine on while working with the grinding
mechanism. This may cause severe injury.
Always unplug the power cord from the power
outlet.