Device Network Configuration - Emerson Rosemount 702DX22 Reference Manual

Reference Manual
00809-0200-4702, Rev CA
6.3

Device network configuration

To communicate with the Gateway, and ultimately the Information System, the transmitter
must be configured to communicate with the wireless network.
Entering the network ID and join key
Using a Field Communicator or AMS Wireless Configurator, enter the Network ID and Join Key so
they match the Network ID and Join Key of the Gateway and the other devices in the network. If
the Network ID and Join Key are not identical, the transmitter will not communicate with the
network. The Network ID and Join Key may be obtained from the Gateway on the Setup>Net-
work>Settings page on the web server. Using a Field Communicator, the Network ID can be
configured by entering the Fast Key Sequence: 2, 2, 1, 1. The Join Key can also be configured
using a Field Communicator with the Fast Key Sequence: 2, 2, 1, 2.
Changing the update rate with a field communicator
The final device network configuration piece is the Update Rate which, by default, is 1 minute. It
can be changed at commissioning, or at any time, by using AMS Wireless Configurator or the
Gateway's web server. The Update Rate should be between 1 second and 60 minutes. To change
the Update Rate with a Field Communicator, use the Fast Key Sequence: 2, 2, 1, 3.
Configuring on the bench
If doing a bench top initial configuration, after completion remove the power module until
installation. When the device is installed, insert he power module and close the housing cover
securely. Always ensure a proper seal so that metal touches metal, but do not over tighten.
Configuration: Models 702DX32 and 702DX42
Section 6: Configuration: Models 702DX32 and 702DX42
February 2013
57