Device Configuration; Device Network Configuration - Emerson Rosemount 3308 Reference Manual

Rosemount 3308
DEVICE
CONFIGURATION
DEVICE NETWORK
CONFIGURATION
Figure 3-6. Gateway Network
Settings
3-6
PRELIMINARY
Remove the Power Module-side housing cover to expose the terminal block
and HART communication terminals, then connect the Power Module to
power the unit for configuration.
The Rosemount 3308 transmitter will receive any HART communication from
a handheld Field Communicator or AMS Wireless Configurator. When using a
Field Communicator, any configuration changes must be sent to the
transmitter using the Send key (F2). AMS Wireless Configurator configuration
changes are implemented when the Apply button is clicked.
®
AMS Wireless Configurator
AMS Wireless Configurator is capable of connecting to devices directly, using
a HART modem, or remotely using the Gateway.
When configuring on the bench with a HART modem, double click the device
icon, then choose the Configure/Setup tab (or right click and select
Configure/Setup). Configure the device settings using the Direct Connection
menu.
When configuring with the Gateway, double click the device icon then choose
the Configure/Setup tab (or right click and select Configure/Setup). Configure
the device settings using the Wireless Connection menu.
To communicate with the Gateway, and ultimately the host system, the
transmitter must be configured to communicate with the wireless network.
Using a Field Communicator or AMS Wireless Configurator, enter the
Network ID and Join Key so they match the Network ID and Join Key of the
Gateway and the other devices in the network. If the Network ID and Join Key
are the same as the Gateway, the transmitter will not communicate with the
network. The Network ID and Join Key may be obtained from the Gateway on
the Setup>Network>Settings page on the Gateway's integrated web server,
shown in Figure 3-6.
Reference Manual
00809-XXXX-4811, Rev AA
February 2012