TOMAHAWK
®
1000
OPERATION
GOUGING SETUP:
If gouging metal and not cutting completely through the part is
required, a special gouging nozzle is used in conjunction with a
gouge shield to protect the nozzle from molten metal blow back.
Refer to the torch parts decal located on your machine or the parts
3-10
pages at the back of this manual for the specific part numbers
required for each of these setups.
ALWAYS USE GENUINE LINCOLN ELECTRIC ELECTRODES,
NOZZLES, AND EXPENDABLE PARTS FOR THE BEST CUTTING
PERFORMANCE.
www.lincolnelectric.com
B-10