Page 1
INSTALLATION OPERATING INSTRUCTIONS Model: VERTICAL CONTACT BUN GRILL TOASTER INTENDED FOR OTHER THAN HOUSEHOLD USE RETAIN THIS MANUAL FOR FUTURE REFERENCE TOASTER MUST BE KEPT CLEAR OF COMBUSTIBLES AT ALL TIMES FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Page 2
IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or Parts, this information is required. Model Number Serial Number Date Purchased Notes:...
The user places both buns into the top of the toaster and two perfectly caramelized, warm buns (4 halves) will slide out of the bun chute. The VCG will toast two buns, crown and heel, in 8 seconds.
2. SAFETY INFORMATION APW Wyott toasters are designed, built, and sold for commercial use and should be operated by trained personnel only. Clearly post all CAUTIONS, WARNINGS and operating instructions near each unit to insure proper operation and to reduce the chance of personal injury and/or equipment damage.
4. OPERATION Operating Instructions This toaster is for Dry operation only Ensure Release sheets are properly installed. (See page 9.) Turn Main Power Switch on. Set Temperature Control to desired temperature. (Temperature is factory set at 600°F.) Allow Pilot Light to cycle at least two times (on/off). When the light is on, the grill is heating. Heat up time is about 15 minutes.
5. CLEANING Cleaning Instructions Toaster is for DRY BUNS ONLY. put buttered bread products in the toaster. Note: To save time at closing (it will take 15 minutes for toaster to cool down), you might want to have the day shift clean the toaster.
CLEANING (EN ESPAÑOL) El Procedimiento de Limpieza Tostador es SOLO PARA LOS BOLLOS SECOS. No ponga los productos de pan unta dos con mantequilla en la tostadora. Tostador con Parrilla de Contacto Vertical Instrucciones Para Limpiar el Tostador Solamente Ponga Bollos Secos en el Tostador En el Tostador no se Debe Poner Pan u Otro Tipo de Alimentos Untados con Mantequilla Nota:...
Release Sheet Replacement 1. Turn toaster off. 2. Remove the top cover. 3. Remove old release sheet from the toaster platen (grill).!!! CAUTION !!! TOASTER PLATEN MAY BE HOT. 4. If the reverse side of the release sheet is still good, then fold the release sheet the opposite way and use the other side.
Page 10
Problem No heat and conveyor Toaster is installed incorrectly. belts don’t move. Lid not placed on top securely. Manual High Limit switch tripped open. Defective components or wiring problem No heat and conveyor Temperature Controller belts move. Solid-state relay failure Inoperative Platen or Wiring Problem Set-point is too low Platen is hot and...
Lid Rattles toaster and does not requi field service. If unsure, call Chains emit squeaking or skipping noise or any the APW Wyott technical noise indicating metal is rubbing on metal. service department.) Belt wrap pin rubbing on metal housing.
7. PREVENTATIVE MAINTENANCE SCHEDULE Tools required: Daily: Heat Resistant Gloves, Standard Cleaner, Standard Sanitizer, Soft Towels. Monthly: Needle Nose Pliers, Soft Brush Yearly: Phillips Screwdriver, Standard Lubricating Oil Preventative Maintenance - WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt.
Page 13
WARNING! Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt. In addition to the daily cleaning described above, remove and clean silicone belt. Remove the top cover and bun chute and clean with detergent in a sink.
Page 14
If the sprockets are not engaging all the wires, if the metal belt is too loose, making noise, or exhibits any other indication of being unusually loose, call an authorized APW Wyott Service Technician.
Manual Limit Sw. N.C. Relay Yellow “K” T/C Temperature Output Control Out Com AC Input From 81600321 Switch Main Power White or Blue Wire From Cord Black or Brown Wire From Cord Green Wire From Cord Limit Sw. N.C. From 81600321 Sensor Blue Black-White...
Two to three rotations of the knob should be enough to center the belt on the conveyor. Also see the flow diagram on page 16 for belt tracking instructions. PARTS LIST - VCG TOASTER DESCRIPTION 85640...