Hotpoint Ultima FDW85 Service Information page 19

S. Sump Assembly
1. Remove the lower basket, filters and lower spray arm.
2. Insert Special Tool (Part Number 5600269) into the sump retaining ring as in Figs. 1 and 2
above.
3. Turn the tool anti-clockwise to remove the sump retaining ring.
The sump retaining tool can also be used to assist in refitting the sump retaining ring.
4. Remove the dishwasher base tray (H).
5. The sump has a locating peg which should be lined up with a cut out in the sump opening.
Fig. 3
6. Carefully line up the peg in the sump assembly with the small recess in the hole in the tank.
See Figs. 3 and 4. Tip the machine back slightly and slide the block supplied with the Special
Tool (Part Number 5600269) or similar support under the flat area of the sump. Carefully lower
the machine onto the support, taking care not to trap any wiring, damage the drain pump or
distort the tank.
7. Check that the sump is still aligned with the cut out and fits centrally into the tank opening.
8. The sump retaining ring is a bayonet fitting and should be lined with the 3 bayonet pegs on the
sump.
9. Using the Special Tool as in Fig. 1, turn the ring clockwise until the retaining ring reaches its stop
position.
10. Check the ring is fixed securely and that the 3 bayonet pegs are located under the retaining ring.
Fig. 1
Fig. 2
19
Fig. 4