Hotpoint Ultima FDW85 Service Information page 18

N. Turbidity Sensor
1. Remove the base panel as in (B).
2. Remove the heater as in (M).
3. Slacken the hose clip securing the sensor hose to the circulation motor. See (L8).
4. Remove the retaining screw from the connector block on the sensor and remove the connector,
making special note of the orientation of the plug, as it is not keyed.
O. Fill Valve
1. Remove the left hand side panel as in (D).
2. Remove the upper rear support (L shaped bracket mounted above the fill valve).
3. Slide the valve upward to disengage it from the lower rear support.
4. Disconnect the wiring from the 2 pin connector.
5. Remove the hoses.
6. Replace in reverse order.
P. Mains Neon
1. Remove the console as in (F).
2. The neon can be removed by pulling out gently from the holder.
Q. Pressure Switch
1. Remove the right hand side panel as in (D).
2. Access can now be gained to the pressure switch mounted at the front of the chassis.
If the pressure hose is removed or replaced for any reason, it is important that it is refitted into
the clip on the side of the tub assembly. Failure to do so will affect the operation of the pressure
switch.
R. Turbo Dry Fan & Condenser - Fitted before Serial Number 50412.0000
1. Remove the top cover as in (A).
2. Remove the kickstrip as in (B).
3. Remove the right hand side panel as in (D).
4. From the inside of the tub remove the condenser vent cap by turning it anti-clockwise.
5. Disconnect the wiring to the fan (2 pin connector adjacent to the pressure switch). It may be
easier to remove the base panel to gain access to the 2 pin connector.
6. Lift the condenser assembly off the chassis locating studs.
7. Remove the hose from the condenser.
8. Replace in reverse order.
Note: - The fan and condenser are supplied as a complete assembly.
18