Hotpoint Ultima FDW85 Service Information page 16

SERVICING NOTES & DISMANTLING INSTRUCTIONS
SAFETY NOTES:-
1. ENSURE THAT THE MACHINE IS UNPLUGGED BEFORE DISMANTLING.
2. BEWARE OF SHARP EDGES ON METAL PANELS AND PRESSED PARTS.
A. Top Cover
1. Remove the two screws at the rear securing the top.
2. Slide the top forward to remove.
B. Kickstrip
1. Carefully tilt the dishwasher back.
2. Remove the 2 screws securing the kickstrip to the chassis.
3. Pull the kickstrip forward to remove.
C. Outer Door Panel
1. Remove the 8 screws from the side flanges of the inner door.
2. Slide the door panel down to disengage from the locating lugs.
D. Side Panels
1. Remove the top cover as in (A).
2. Remove the kickstrip as in (B).
3. Remove the kickstrip end caps.
4. Remove the 11 screws securing each side panel (4 front, 2 top, 5 rear).
E. Base Panel
1. Remove the 3 screws at the rear of the base panel securing the panel to the chassis.
2. Carefully tilt the machine backwards and lay the machine on its back.
3. Remove the 3 screws securing the base panel at the front of the chassis.
4. Disconnect the wiring to the float switch and remove the base panel.
5. Replace in reverse order.
F. Console
1. Remove the outer door panel as in (C).
2. Remove the 6 screws securing console to the inner door panel.
3. Replace in reverse order.
G. Control Module
1. Remove the console as in (F).
2. Remove the outer door panel as in (C).
3. Remove the polystyrene insulation from the inner door panel.
4. Unclip the thermistor from its mounting position on the inner door next to the dispenser.
5. Remove the 3 screws securing the module bracket to the console.
6. Disconnect wiring from the module, making note of the connections.
7. Replace in reverse order.
H. LCD Display Module
1. Remove the console as in (F).
2. Remove the outer door panel as in (C).
3. Disconnect the wiring to the display module making special note of the connections.
4. Remove the 2 screws securing the display module to the console.
5. Replace in reverse order.
16