Attribute
Disengaging time
Figure 2.9-1 shows the operate times for the four IEC IDMTL curves with a time multiplier of 1.
Figure 2.9-2 and Figure 2.9-3 show the ANSI operate and reset curves. These operate times apply to non-
directional characteristics. Where directional control is applied then the directional element operate time should be
added to give total maximum operating time.
©2010 Siemens Protection Devices Limited
7PG2113/4/5/6 Performance Specification
Value
< 50 ms
Chapter 3 Page 24 of 42