Wall Mount; Prepare The Wall - Wolf 801642 Quick Start Manual

WALL MOUNT

For use with Wolf CTWH30/CTWH36 wall mount, IH4227 island chimney hoods, DD30R/DD36R downdraft ventilators, 18" tall
island/wall hoods & 12" tall liners.

PREPARE THE WALL

17" 17"
1¼" dia. hole 1¼" dia. hole
Pilot Hole Pilot Hole
(centered between studs) (centered between studs)
11
14 / "
16
REMOVE REMOVE
SIDING SIDING
11 11 13 13 / / " "
16 16
From inside the wall:
q 1
Drill a PILOT HOLE through the wall, centered between
WALL STUDS.
From outside - on the wall:
q 2
Measure and mark the 22" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
q 3
Measure and mark the 11" DIAMETER HOLE and the
1¼" DIAMETER HOLE. Cut these holes all the way through
the wall.
INSTALLATION
3"
11" dia. 11" dia.
hole hole
22" 22"
WIRE THE VENTILATOR
q 4
Remove 10
COVER SCREWS
and lift off
ventilator cover.
q 5
Feed the electric
power cable
through the 1¼"
DIAMETER HOLE
and connect cable
to ventilator with a
proper connector
for the type of
cable being used.
29½" 29½" q 6
Connect BLACK
TO BLACK,
WHITE TO BLUE,
and GROUND TO
GROUNDING
SCREW.
INSTALL THE VENTILATOR
10 Cover 10 Cover 10 Cover
Screws Screws Screws
Flashing Flashing
Sheet Sheet
q 7
Place ventilator on wall so that ventilator's discharge collar
fits into 11" diameter hole.
q 8
Use the 6 screws (provided) to attach the ventilator to the
wall. DRILL 6 MOUNTING HOLES inside the ventilator, as
necessary.
q 9
Seal the screw heads and edges of the flashing sheet with
a good grade of roofing cement.
q 10
Check for free movement of the spring-loaded DAMPER
and re-install ventilator cover. Turn on power and check
operation.
MODEL 801642
GROUND
TO
GROUNDING
SCREW
WHITE
TO
BLUE
BLACK TO BLACK
Damper
Bird Screen Bird Screen
OUTSIDE - ROOF VIEW OUTSIDE - ROOF VIEW OUTSIDE - ROOF VIEW OUTSIDE - WALL VIEW
Page 3
120
VAC
LINE
IN
Drill 6 Drill 6
Mounting Mounting
Holes Holes