Wall Mount; Prepare The Wall - Wolf 812307 Manual

waLL MOUnT

For use with Models ICBPW3048, ICBPW3648, ICBPW448, ICBPW4848, ICBPW5448,
ICBPW3078, ICBPW3678, ICBPW478, ICBPW4878, ICBPW5478, ICBPL34,
ICBPL46, ICBPL5, ICBDD30R,
ICBDD36R, ICBDD45R

prepare the wall

24¾"
10¾"
8½"
12 / "
7
8
Pilot Pilot
Hole Hole
1¼"
dia. hole
OUTSIDE - WALL VIEW
From inside the wall:
1
Drill a PiLOT HOLE through the wall, 8½" from the inside
edge of a waLL STUD.
From outside - on the wall:
2
Measure and mark the 25" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
3
Measure and mark the 11" DiaMETEr HOLE and the 1¼"
DiaMETEr HOLE. Cut these holes all the way through the
wall.
inSTaLLaTiOn
REMOVE
SIDING
11" dia.
hole
9 1 / "
8
7¼"
install the Ventilator
4
Remove 7 COVEr SCrEwS and lift off ventilator cover.
5
Remove and discard SHiPPing CarDBOarD from blower
wheel.
6
Feed the electric power cable (supplied with ventilator)
through the 1¼" DiaMETEr HOLE in wall.
7
Position ventilator on wall so its discharge collar fits into 11"
diameter hole.
8
Use 6 screws (provided) to attach ventilator to wall. 6
MOUnTing HOLES are provided.
9
Seal screw heads and edges of flashing sheet with a good
grade of roofing cement or other sealant.
10
Check for free movement of spring-loaded damper and
re-install ventilator cover.
28¼"
7 Cover 7 Cover
Screws Screws
attach power cords to hood
11
The ventilator is prewired with 12 feet of H05VV-F
3G1 power cable. Run ventilator cable to range hood's
electrical wiring box.
12
Secure cable to range hood with a strain relief (included
in parts bag). Make wiring connections per instructions
provided with your Wolf range hood.
13
Install the separate power cord and strain relief (included
in parts bag) to the range hood. Refer to instructions
provided with your Wolf range hood.
14
Turn on power and check for proper operation of
ventilator.
MODEL 812307
Shipping
Cardboard
Wiring
Cover
Bird Screen
Flashing Sheet
OUTSIDE - WALL VIEW
Page 3
6
Mounting
Holes