Wall Mount; Prepare The Wall - Wolf 801640 Manual

WALL MOUNT

For use with Wolf CTWH30/CTWH36 wall mount, IH4227 island chimney hoods, 10" tall & 30" wide x 18" tall wall hoods.

PREPARE THE WALL

10¾" 10¾"
8½" 8½"
12 12 7 7 / / " "
8 8
Pilot Pilot Pilot
Hole Hole Hole
1¼" 1¼"
dia. hole dia. hole
OUTSIDE - WALL VIEW OUTSIDE - WALL VIEW
From inside the wall:
q 1
Drill a PILOT HOLE through the wall, 8½" from the inside
edge of a WALL STUD.
From outside - on the wall:
q 2
Measure and mark the 25" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
q 3
Measure and mark the 11" DIAMETER HOLE and the
1¼" DIAMETER HOLE. Cut these holes all the way
through the wall.
INSTALLATION
25" 25"
REMOVE REMOVE
SIDING SIDING
11" dia. 11" dia.
hole hole
9 9 1 1 / / " "
8 8
7¼" 7¼"
WIRE THE VENTILATOR
29½" 29½"
q 4
Remove 7 COVER SCREWS and lift off ventilator cover.
Remove BIRD SCREEN and WIRING COVER.
q 5
Feed the electric power cable through the 1¼" DIAMETER
HOLE and connect cable to ventilator with a proper
connector for the type of cable being used.
q 6
Connect BLACK TO BLACK, WHITE TO WHITE, and the
GREEN TO GREEN or bare wire. Replace wiring cover.
INSTALL THE VENTILATOR
7 Cover 7 Cover 7 Cover
Screws Screws Screws
q 7
Remove SHIPPING CARDBOARD from blower wheel.
q 8
Place ventilator on wall so that ventilator's discharge collar
fits into 11" diameter hole.
q 9
Use the 6 screws (provided) to attach the ventilator to the
wall. 6 MOUNTING HOLES are provided.
q 10
Seal the screw heads and edges of the flashing sheet
with a good grade of roofing cement.
q 11
Check for free movement of the spring-loaded damper,
re-install BIRD SCREEN and ventilator cover. Turn on
power and check operation.
BLACK
TO
BLACK
WHITE
120 VAC
GREEN
TO
LINE IN
WHITE
GREEN
Shipping Shipping
Cardboard Cardboard
Wiring
Cover
Bird Screen Bird Screen
Flashing Sheet
OUTSIDE - WALL VIEW OUTSIDE - WALL VIEW
MODEL 801640
Page 3
TO
6 6
Mounting Mounting
Holes Holes