Wolf BM-Solar Installation And Operating Instructions Manual page 11

A : 0 7
SM1: Not installed
SM2: Input E3
A : 0 8
SM1: Not installed
SM2: Maximum DHW
temperature
Solar cylinder 2
A : 0 9
SM1: Not installed
SM2: Maximum collector
temperature
Collector array 2
A : 1 0
SM1: Hours run
Solar circuit pump
SM2: Hours run
Solar circuit pump 1
A : 1 1
SM1: Not installed
SM2: Hours run
Solar circuit pump 2
A : 1 2
Current output
3061916_0611
Display level
SM1: Not installed
SM2: The current value captured by the sensor connected
to input E3 is displayed. Subject to the configuration
set at the SM2, this may be the buffer temperature, the
actual DHW temperature of solar cylinder 2, the collector
temperature of collector array 2 or the bypass temperature.
This value will only be displayed if a temperature sensor
has been connected.
SM1: Not installed
SM2: The maximum DHW temperature of cylinder 2 over the
course of 24 hours is displayed.
This value is reset every 24 hours.
SM1: Not installed
SM2: The maximum collector temperature of collector array 2
over the course of 24 hours is displayed.
This value is reset every 24 hours.
SM1: The overall hours run by the solar circuit pump are displayed.
SM2: The overall hours run by solar circuit pump 1 are displayed.
This value corresponds to the display value x 10.
This value can be reset to 0 by pressing and holding down
the rotary selector for at least 10 seconds.
SM1: Not installed
SM2: The overall hours run by solar circuit pump 2 are displayed.
This value corresponds to the display value x 10.
This value can be reset to 0 by pressing and holding down
the rotary selector for at least 10 seconds.
SM1/ The current output of the solar circuit is displayed.
SM2: This value is only available if a return sensor or a heat meter
set has been connected to the associated SM solar module,
and value 1 or 2 has been selected for parameter 08.
11