Factory Reset; Firmware Upgrade - Planet Networking & Communication IHD-210PR User Manual

Description
Information then the OSD will turn off automatically.
2. Info Display On Mode: The selected RX will always show OSD.
3. Info Display Off Mode: The selected RX will not show OSD.
Setting the selected Tx group ID -- The maximum is up to 64 groups from 0 to 63.
After changing the setting, please click the update button to make the change
effective.
Group ID
Setting the baud rate of RS232 extension on the selected Rx --
UART Baud
After changing the setting, please click update button to make the change effective.
Rate
Note that the baud rate of Tx and Rx should be the same.
MAC Address Display the Ethernet MAC address of the device. Note that user cannot change it.
Setting the selected Tx name for identification –
Device Name Up to 32 digits is accepted for the device name setting. After changing the setting,
please click the update button to make the change effective.
If the Rx Device Selection can't load device properly, please make sure the PC's IP address
is in the same subnet as IHD-210PR.

4.1.5 Factory Reset

When the system is unstable or setting incompletely, please click on "Factory Reset" to recover the
initial default of the system.

4.1.6 Firmware Upgrade

User is able to upgrade firmware via IPTV Control Center.
Please refer the the steps below:
1. Stop transmitting video between IHD-210PT and IHD-210PR.
2. Click on "Firmware Upgrade".
After rebooting, the Group ID will follow the hardware Group setting.
32
High Definition HDMI Extender over IP with PoE
Function
IHD-210PT / IHD-210PR