Interfaces - Planet Networking & Communication IHD-210PR User Manual

1.5.2 Interfaces:

Transmitter (IHD-210PT)

Interfaces Definition:
Position Description
1 DC 5V
2 Ethernet (PoE)
3 HDMI Out
4 HDMI In
5 IR
6
RS232
7 Channel
8 Group
9 Reset
5V/2A DC power input.
Only use one power source, either from DC or from 802.3af/at PoE+
Ethernet switch.
 Connect to a LAN Switch.
IGMP snooping and jumbo frame supported Gigabit IEEE 802.3af/at
PoE+ Ethernet switch is recommended.
 LED.
1. LAN LED (green color):
This LED will be flashing while network is accessing via Ethernet.
2. Power LED (orange
When the device is powered on, and the device is connected to
Ethernet switch, the LED will be always on.
HDMI Type A female connector for video output.
HDMI Type A female connector for connecting to the HDMI source (built in
transmitter,
Transmitter: 3.5mm jack for IR emitter cable to control video source device.
Receiver: 3.5mm jack for IR receiver cable to receive signal from remote
controller.
DB-9 female connector for RS232 bi-directional remote extension.
Display group indication.
Group configuration, 6-bit switch for 64 stream channel selection.
Power on the device and press the reset button for over one second to
restore it to factory default settings.
14
High Definition HDMI Extender over IP with PoE
Receiver (IHD-210PR)
Function
color):
IHD-210PT / IHD-210PR