Chapter 2. Hardware Installation; Devices Requirements; Installation Instructions - Planet Networking & Communication IHD-210PR User Manual

Chapter 2.

2.1 Devices Requirements

1. Monitor: HDCP compliant monitors with HDMI interface for the HDCP video source.
2. Ethernet cable: Cat5/5e/6 UTP cable (EIA/TIA 568B industry standard compliant).
3. PoE Switch: Please see the recommended PoE switch.
4. PC OS: Windows XP/7/8.1/10.
Application
Video Extend Application
The quality of the output signal will depend largely upon the quality of video source, cable
and display device used. Low-quality cables degrade output signal causing elevated noise
levels. Please use the proper cable and make sure the display device is capable of handling
the resolution and refresh rate selected.

2.2 Installation Instructions

1. Connect the video source to the Transmitter (IHD-210PT) unit's HDMI In interface.
2. Connect the monitor to the Receiver (IHD-210PR) unit's HDMI Out interface.
3. Use Cat5e/6 cables (EIA/TIA 568B industry standard compliant) for connection between
Transmitter/Receiver and the IEEE 802.3af/at PoE+ switch.
4. Set an identical ID number on DIP switch for all units of the same group.
5. Connect the IR emitter cable to Transmitter, and connect the IR
(optional)
6. Apply the proper power to all connecting devices.
1. Ensure that all devices are powered off before connecting to the unit.
2. Make sure all devices connected are properly grounded.
3. Place cables away from fluorescent lights and air conditioners that are likely to generate
electrical noise.
4. Please allow adequate space around the unit for ventilation.
Hardware Installation
Gigabit PoE Switch with IGMP snooping function
High Definition HDMI Extender over IP with PoE
Recommended Ethernet Switch
receiver
17
IHD-210PT / IHD-210PR
cable to Receiver.