Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual page 135

Mechanical installation
...................................................................................................................................................................................................................................
Mounting of special fiber guides
Important! The following procedure must only be performed if it is necessary to
route fiber cables within the rack extension (width). In that case special fiber guides
which are part of the rack extension kit (CC848894416) must be mounted on each
subrack. The upper fiber guides which are delivered with the subrack (with cable
trough) are not used. The fiber guide kit, which includes the special fiber guides, can
also be ordered separately (CC848957734).
Reference: The rules related to the use of special fiber guides and rack extensions
(width) are given in chapter 4, section
Proceed as follows to mount the special fiber guides:
...................................................................................................................................................................................................
1 Mount one fiber guide (right) (DC2009439, item 1) on the top right side of each subrack
using two self-tapping screws (DC1002024) as shown in
mounting" (p.
OTE: The mentioned screws, which are also part of the fiber guide kit, must be used
because they are longer than the normal ones.
...................................................................................................................................................................................................
Mount one fiber guide (left) (DC2009433, item 2) on the top left side of each subrack in
2
the same way.
...................................................................................................................................................................................................
Mount one side guide (DC2009437, item 3) on both bottom side panels of each subrack
3
using two M2.5x6 screws.
...................................................................................................................................................................................................
4 Route a velcro tape (item 4) through the cutouts of each side guide.
E
N D O F
...................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-374-198R10.5.4
Issue 1 July 2009
3-32).
S T E P S
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Procedure 3-8: Mounting the subracks into rack
"Fiber engineering rules" (p.
Figure 3-17, "Fiber guide
ETSI-2 installation
4-88).
3-31