Table of Contents
Advertisement
General Information
General
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES. Installer
must mark unit nameplate with Heater Information per instructions on nameplate.
Note: If digit 9 in the unit model number equals "E" (Electro Mechanical Control), accessory relay
Figure 1. Electro Mechanical wiring diagram
Inspection
1. Unpack all components of the kit.
2. Check carefully for any shipping damage. If any damage is found it must be reported
3. Check the heater nameplate model number and compare with
6
BAY24X042 is required if the thermostat does not energize the fan circuit in the heating
mode. See
Figure 1
for wiring information.
immediately and a claim made against the transportation company.
Table 6, p.
17,
Table 9, p.
model number complies with the particular heater being used.
19, or
Table 10, p.
19. Ensure that the available power supply and unit's
Table 4, p.
14,
Table 5, p.
ACC-SVN67D-EN
16,
Hide quick links:
Advertisement
Table of Contents
