Advertisement
INSTALLER'S GUIDE
Section 2. General Information
This electric heater accessory is designed to provide
power directly to the air handler from the accessory
heater's power supply, eliminating the need for addi-
tional circuits. The power and control wiring each use
a single wire harness to connect the heater and the air
handler.
1. Check the heater nameplate to confirm that the selected
heater is approved for use with the air handler.
2. Check the components received for damage. Report
any defects or shortages to the transportation company
immediately.
3.
Be sure the power supply matches the listing shown on
the heater nameplate.
4. On the air handler models with the 410A refrigerant, select
the label with the installed heater model number and apply
it to the section of the nameplate with the equivalent kW
heater number.
Section 3. Heater Assembly Labeled
Breaker Bracket Cover
Circuit Breakers
Electric Heat Control - 24V
Page 2
Heater Element
Terminations
Edge Guard
- in document pack
Electric Heat
Control Platform
Breaker Bracket
Heater Rack
Nameplate
Base Plate
Non-cyclic
Thermal Limit Switch
Cyclic Thermal
Limit Switch
Width Adjustment Brackets
Heater Baffle
Retainer Tabs and screws
- in document pack
Non-cyclic
Thermal Limit Switch
Advertisement
