Merchandiser Leveling; Leg Installation; Serial Plate Location - Hussmann HGM-3 BS Installation & Operation Manual

P/N 0515297_E

MERCHANDISER LEVELING

B
e sure to position merchandisers
. Level the merchandiser at corners.
properly
Merchandiser(s) must be installed level to
ensure proper operation of the refrigeration
system and to ensure proper drainage of
defrost water. The merchandiser can be leveled
by shimming under the cabinet base frame, or
by installing optional leg levelers.
The self-closing doors require the cabinet to be
properly leveled. End to end leveling will allow
the door(s) to close with uniform speed and
tightness. A slight pitch from front to rear
is desirable. t
he Back of merchandiser
should never Be higher than the front
(HGL-BS Shown)
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
LEG INSTALLATION (Top Mounts Only)
Install the NSF approved legs after the case is
near its final location. The legs are packaged
inside the cabinet. Replace the tape and door
blocks.
To install legs:
Raise one end of the cabinet about 8 inches.
Block the merchandiser securely, and install
two legs. The leg mounting plates are factory
installed and contain a
to mate with the leg assembly. The procedure
is repeated on the opposite end. Three-door
merchandisers require legs in the center.
. The cabinet should now be positioned at its
final location with all legs installed. The
merchandiser is leveled by turning the bottom
section of each leg . End to end leveling will
make the door(s) close with uniform speed and
tightness. A slight pitch from front to rear is
desirable.

SERIAL PLATE LOCATION

The serial plate is located in the upper left-
hand corner of the merchandiser's interior.
The serial plate contains all pertinent
information such as model, serial number,
amperage rating, refrigerant type and charge.
Do not remove the serial plate under any
circumstance.
Serial Plate
Drain
1-5
1
/ x 13 in. tapped hole
2
HGM Merchandisers