Merchandiser Leveling; Optional Legs; Serial Plate Location; Refrigeration Unit Access - Hussmann SHM Installation & Service Manual

Medium temperature self contained specialty horizontal merchandiser
Table of Contents

Advertisement

I
1-4
NSTALLATION

MERCHANDISER LEVELING

B
E SURE TO POSITION MERCHANDISERS PROPERLY
Level the merchandiser by all four corners.
Merchandiser(s) must be installed level to
ensure proper operation of the refrigeration
system, and to ensure proper drainage of
defrost water. Optional leg levelers can be
provided for this purpose.

OPTIONAL LEGS

NSF
®
approved legs replace the leg levelers if
required by local health codes. The legs raise
the case 6 inches for cleaning purposes. An
optional skirt kit can be provided to snap on
the legs.

SERIAL PLATE LOCATION

The serial plate is located on the interior left
wall of the merchandiser. It contains all pertinent
information such as model, serial number,
amperage rating, refrigerant type and charge.
This information will be needed to install, service
or order parts for the merchandiser.
P/N 0515258_E

REFRIGERATION UNIT ACCESS

The lower access panel may be removed by
.
lifting the panel straight upward and over the
screws on which it is hanging. The panel is
installed by reversing the above procedure.
Ensure lower access panel is flat against the
floor when installed to prevent air circulation
problems on self contained merchandisers.

SEALING MERCHANDISER TO FLOOR

If required by local sanitary codes, or if the
customer desires, merchandisers may be sealed
to the floor using a vinyl cove base trim. The
size needed will depend on how much variation
there is in the floor, from one end of the mer-
chandiser to the other. Sealing of the lower
front and rear panels on self contained models
may hamper their removal for servicing or
maintenance of the condensing unit.
Serial Plate
NOTE: Do not allow trim to cover any intake
or discharge grilles located in the lower front
panel.
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
Safe-NET III Display
Front Panel
Safe-NET III display is
mounted on left side of
access panel. Be careful not
to detach Safe-NET III
cable from display when
removing access panel.
Lift up and
out to remove
access panel
Safe-NET III
Display

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shm-3Shm-4Shm-4bw

Table of Contents