Honda CRF450L 2019 Owner's Manual & Off-Road Handbook page 64

Subframe
12. Connect the turn signal light connectors (35).
Connect the license light/taillight/brake light
connectors (36). Set the connector covers (37)
to the rear fender stays (38).
Secure the wire harness (33) with the wire
harness band (39).
(39)
(37)
(33)
(38)
(38)
(36)
(33) wire harness
(35) turn signal connectors
(36) license light/taillight/brake light connectors
(37) connector covers
(38) rear fender stays
(39) wire harness band
58
Servicing Your Honda
13. Install the rear fender (40), then tighten the rear
fender mounting screws (41) to the specified
torque:
1.1 lbf·ft (1.5 N·m, 0.2 kgf·m)
(35)
(40) rear fender
14. Route the negative (-) battery cable (42)
properly, secure it with negative (-) battery
cable bands (43).
(43) (42)
(42) negative (-) battery cable
(41)
(40)
(41) screws
(43)
(42)
(43) cable bands
15. Connect the crankcase breather tube (43) and
air injection air tube (44) to the air cleaner
housing (1). Connect the IAT sensor connector
(45).
Tighten the air cleaner connecting tube clamp
screw (46) so the clamp ends is 0.30 ±0.06
in(7.5 ± 1.5 mm).
(1)
(43)
(44)
0.30 ± 0.06 in
(7.5 ± 1.5 mm)
(1) air cleaner housing
(43) crankcase breather tube
(44) air injection air tube
(45) IAT sensor connector
(46) connecting tube band screw
(45)
(46)