General Competition Maintenance (Off-Road Use Only) - Honda CRF450L 2019 Owner's Manual & Off-Road Handbook

General Competition Maintenance (Off-Road Use Only)

Perform maintenance on firm, level ground using
the side stand, an optional workstand, or
equivalent support.
When tightening bolts, nuts or screws, start with
the larger diameter or inner fasteners, and tighten
them to the specified torque using a crisscross
pattern.
Use Honda Genuine Parts or their equivalents
when servicing your motorcycle.
Clean parts in non-flammable (high flash point)
cleaning solvent (such as kerosene) when
disassembling. Lubricate any sliding surfaces,
O-rings, and seals before reassembling. Grease
parts by coating or filling where specified.
After any engine disassembly, always install new
gaskets, O-rings, cotter pins, piston pin clips, snap
rings, etc. when reassembling. After reassembly,
check all parts for proper installation and
operation.
All Pre-ride Inspection Items
Refer to Pre-ride Inspection on page 19.
39
Servicing Your Honda