More Options; Caring For Your Device - ResMed AirCurve 10 CS PaceWave User Manual

To stop Mask Fit, press the dial or Start/Stop. If you are unable to get a good mask seal, assess
whether you have the right mask size and/or type or talk to your care provider.

More options

There are some more options on your device which you can personalise.
Leak Alert*
SmartStart*
*When enabled by your care provider.

Caring for your device

It is important that you regularly clean your AirCurve 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
WARNING
Regularly clean your tubing assembly, humidifier and mask to receive optimal therapy and to
prevent the growth of germs that can adversely affect your health.
Disassembling
1. Hold the humidifier at the top and bottom, press it gently and pull it away from the device.
2. Open the humidifier and discard any remaining water.
3. Hold the cuff of the air tubing and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
8
When Leak Alert is enabled, the device beeps if the mask leaks too much air or if you remove
the mask during therapy.
When SmartStart is enabled, therapy starts automatically when you breathe into your mask.
When you remove your mask, it stops automatically after few seconds.