More Options; Working With Alarms - ResMed AirCurve 10 ST-A User Manual

Mask Fit
Mask Fit is designed to help you assess and identify possible air leaks around your mask.
To stop Mask Fit, press the dial or Start/Stop. If you are unable to get a good mask seal, talk to your
care provider.

More options

There are some more options on your device which you can personalize.
Mask
Run Warm Up
Ramp Down*
SmartStart*
*When enabled by your care provider.

Working with alarms

The device is fitted with an alarm feature that monitors your therapy and alerts you to changes that
may affect your treatment.
When power is connected to the device, the yellow LED alarm indicator will flash and the alarm will
sound to confirm that the alarm is working.
8
To check Mask Fit:
1. Fit the mask as described in the mask user guide.
2. In My Options, turn the dial to highlight Run Mask Fit and then press the
dial.
The device starts blowing air.
3. Adjust the mask, mask cushion and headgear until you get a Good result.
This option shows your mask type setting. If you use more than one type of mask, adjust this
setting when switching between masks.
This option allows you to pre-heat the water before starting therapy, so that the air is not cold
or dry at the beginning of therapy.
This option is intended to make stopping therapy more comfortable by reducing your pressure
over a fixed 15 minute period.
When SmartStart is enabled, therapy starts automatically when you breathe into your mask.
When you remove your mask, it stops automatically after few seconds.
When an alarm is activated, the yellow LED alarm indicator will flash, the
alarm will sound and a message will appear on the screen.