Table of Contents
Advertisement
8-3. Checking the Fan Belt
(1) Fan Belt Tension
Tension should be optimum when the fan belt has 10 to
15mm slacks, when applying finger pressure (about
98N{approximately 10kgf}) at midpoint between fan pulley
and alternator pulley.
(2) Fan Belt Condition
Check the fan belt for damage and replace if any damage or other fault is found.
(3) Replacing the Fan Belt
Request the authorized distributor where the generator was purchased to replace the fan
belt.
< NOTE >
Use of a loose or damaged fan belt could result in overheating or insufficient charging.
Refer to the User's manual for Engine for adjusting and replacing of the fan belt.
27
Advertisement
Table of Contents
