Global OBD II Diagnostics
Erase Codes
The Erase Codes function deletes DTCs and I/M Readiness data from
vehicle's control module(s). Perform this function with KOEO. Do not
start the engine.
✓
The Erase Codes function may also erase View Freeze Data, O2
Monitor Test, and Diagnostic Monitor Test results depending on
vehicle.
✓
The Erase Codes function sets monitors to inc.
✓
Perform Erase Codes function only after systems have been
checked completely and DTCs have been written down.
✓
After servicing the vehicle, erase stored DTCs and verify no codes
4 4
have been reset. If a DTC returns, problem has not been fixed or other
faults are present.
✓
Depending on which monitor sets a code the vehicle may need to be
driven and the monitor ran before concluding that the fault is repaired.
From Diagnostic Codes Menu:
1. Select Erase Codes.
•Use
key until Erase Codes is
highlighted.
•Press
4 – 16 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
UP or
DOWN arrow
ENTER.
Diagnostic Codes Menu
Read Codes
Pending Codes
Erase Codes
Erase Codes
View Fre eze Data
Review Data
Print Data
Code Lookup