Actron CP9190 User Manual page 109

GM Historic (OBD I) Diagnostics
! WARNING
! WARNING
✓
This function can be performed with KOEO or KOER.
2.
Confirm selection.
LEFT or
•Press
response.
• Press
✓
If a recording currently exists in
memory, a message to Erase Old
Recording is displayed. The Scan
Tool stores only one recording at
a time, so be sure to review it
before erasing it.
Multiple Group Vehicles
✓
Some vehicles display a Select Group screen for recording data.
In these cases, only one group of data can be recorded at a time.
Recording another group of data overwrites the present one.
3. Select Trigger Method.
UP or
•Use
key until desired trigger
method is highlighted.
•Manual Trigger begins
recording when the
key is pressed.
•Trigger on Codes begins
recording when a diagnostic
trouble code (DTC) is stored in
the PCM.
•Select a method and press
✓
If Manual Trigger is selected,
ENTER to begin
press
recording. Trigger on Codes will
not show this screen.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 5 – 5
Never operate the tool while driving. Have another
person assist with the operation of the Scan Tool.
RIGHT to move the brackets to the desired
ENTER.
DOWN arrow
ENTER
ENTER.
Record Data
Previous recording
in memory. Do you
want to erase it and
make a new one?
<Yes> No
Select Trig Method
Manual Trigger Manual Trigger
Trigger on Codes
Record Data
Ready to record
Press ENTER
to start recording.
Press BACK
to exit.
5