Quick Memento - Roland SE-02 User Manual

QUICK MEMENTO

PATCH /SEQUENCE/SONG WRITE :
Press [VALUE], use [value knob] to choose destination, Press [VALUE] to Write, or [EXIT] to cancel
TUNING :
Swicth to patch mode. Hold [TRANSPOSE] and push the [VALUE] knob. Confirm clicking [VALUE] knob.
SYSTEM SETUP:
Hold [EXIT] and power On. Press [1] to [9] for function, and adjust [VALUE] knob. Press [VALUE] to save. Power
cycle to exit.
SYSTEM SETTINGS FOR SE-02 EDITOR:
Enter System Setup, set the param [9] (MIDI THRU) to OFF, param [5] and [6] (send CC / PC) to U-M (Usb/Midi).
Press [VALUE] to save and power cycle.
CLEARING A PATCH / PATTERN / SONG:
- Pattern: Press [COMP] and [PLAY]. Press [9]. Press [VALUE] to clear, or [EXIT] to cancel
- Patch: Press [NOTE] and [GATE]. Press [9]. Press [VALUE] to clear, or [EXIT] to cancel
- Song: Press [EDIT] and [PTN]. Press [9]. Press [VALUE] to clear, or [EXIT] to cancel
PATCH SETUP:
Press [COMP] and [PLAY]. Use the [1] – [9] buttons to select a parameter, and use the [VALUE] knob to edit the
parameter's value.
SEQUENCER SETUP
Press [NOTE] and [GATE]. Use the [1] – [3] or [9] buttons to select a parameter, and use the [VALUE] knob to edit
the parameter's value. Sync is parameter [2] set it to midi or USB for clocking internal step sequencer with a midi
sequencer..
SONG SETUP
Press [EDIT] and [PTN]. Use the [1] – [4] or [9] buttons to select a parameter, and use the [VALUE] knob to edit the
parameter's value. Sync is parameter [2] set it to midi or USB for clocking internal step sequencer with a midi
sequencer.
PATCH BACKUP:
Connect USB cable, Press [2] then power on. A new disk appears. Get datas from the disk. Power cycle to exit.
PATCH RESTORE:
Connect USB cable, Press [3] then power on. A new disk appears. Put datas, eject disk, disconnect USB and wait
until leds blink orange (write). Power cycle to exit.
FACTORY RESET:
Press [1] then power on. Confirm with [MANUAL]. All settings and patches are reset to factory defaults. Power cycle
when finished.
FIRMWARE UPDATE:
Connect USB cable to computer. While holding down the [8] button, turn the power on. Copy .bin file to se-02 drive.
Eject device on USB, disconnect the cable and press [MANUAL] to start update. Power cycle when finished.
Page 34 of 35 Manual V1.03 for firmware V1.11