Connecting The Signal Lines - JRC JSS-2150 Installation Manual

INSTALLATIONS
2.2.9.3

Connecting the signal lines

• Back of NKG-91 main unit
Serial connector
• Back of MF/HF controller (NCM-2150)
Serial connector cover
2-62
Printer cable:
7ZCJD0254A
(1.5 m)
Printer power cable:
DPYC-1.5
or
MVVS-20/0.18*2-6.5P-(8)
Printer power cover
Cable clamp
Connector terminal wiring example for power source
No. Signal name
1 DC +
2
3
緑
Green Black Red
3
Power connector (6.5 V)
Remove the serial connector cover and the cover
over the printer power source. Then connect the
printer connection cable and the printer power cable.
After connecting the power cable, fix it with the cable
clamp and replace the cover over the printer power
source.
Note) When the NKG-91 is installed, set the
printer power
default). For details of the printer power
supply setting, see the NKG-800 section.
Direction Functions
Input
power source
DC - Input
power source
E Ground
－
黒 赤
2 1
supply to 6.5V
DC 6.5 V
max. 2 A
(for printer)
DC +
DC -
(factory